Instruction Manual

FS 360 C-M, FS 410 C-M, FS 460 C-M, FS 490 C-M
English
28
Symbols on choke knob
Run position F – a hot engine is started
in this position or the engine runs in this
position.
Start position } – a cold engine is
started in this position.
Starting the Engine
N Press the manual fuel pump
bulb (4) at least five times – even if
the bulb is filled with fuel.
The choke knob is in the normal run
position F.
N If the engine is cold: Depress in the
outer edge (arrows) of the choke
knob (5) and then turn it to Start }.
Cranking
N Place the unit on the ground: It must
rest securely on the engine's guard
plate and the deflector. Check that
the cutting attachment is not
touching the ground or any other
obstacles.
N Make sure you have a firm footing,
either standing, stooping or
kneeling.
N Hold the unit firmly on the ground
with your left hand and press down
– do not touch the throttle trigger or
throttle trigger lockout.
NOTICE
Do not stand or kneel on the drive tube.
N Hold the starter grip with your right
hand.
N Pull the starter grip steadily.
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
N Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
N Continue cranking until the engine
runs.
N If the engine does not start: Turn the
choke knob to the start position }
and repeat starting procedure.
FS 490
0000-GXX-0832-A0
FS 460
FS 360, 410, 460
4
0000-GXX-0833-A0
FS 360, 410, 460
4
2709BA015 KN
FS 490
FS 360, 410, 460
0000-GXX-0834-A0
5
FS 490
5
2709BA016 KN
6BA011 KN
6BA012 KN