Operation Manual

FS 460 C-M, FS 460 C-M L, FS 490 C-M, FS 490 C-M L
English
20
Mounting the Handlebar
To assemble the swivelling handle
support it is necessary to fit a spring in
the clamps and secure them to the
handle support on the machine.
N Use the spring (5) from the parts kit
supplied with the machine.
N Push the spring (5) into the lower
clamp molding (6).
N Position the clamp moldings (4) with
handlebar (2) on the handle
support (7).
N Do notrotate the handlebar in the
clamp moldings.
N Raise the grip of the wing screw (8)
to the upright position.
N Position wing screw (8) in threaded
insert in handle support (7) –
against pressure of spring (5).
N Position the clamp moldings so that
the tabs (9) on the lower clamp
molding (6) line up with the
slots (10) in the handle support (7).
N Rotate wing screw clockwise until
the lower clamp molding (6) butts
against the handle support (7).
N Only tighten the wing screw
moderately.
3BA005 KN
5
7
3BA006 KN
2
4
8
3BA007 KN
5
8
3BA008 KN
7
6
10
7
9
3BA0009 KN
7
6
3BA010 KN