Instruction Manual

FS 410 C-M K, FS 460 C-M K, FS 490 C-M K
English
22
Fitting the full harness is described in
detail in the leaflet supplied with the
harness.
The type and style of the harness
depend on the market.
Fitting the Harness
N Put on the full harness (1).
N Adjust the length of the strap so that
the carabiner (2) is about a hand’s
width below your right hip.
N Attach the carabiner to the
machine's perforated rail (3) – see
“Attaching Machine to Harness”.
N Find the right attachment point for
the cutting attachment you are
using – see "Balancing the
Machine".
Attaching Machine to Harness
N Attach the carabiner (1) to the
perforated rail (2) on the drive tube.
Disconnecting Machine from Harness
N Press down the bar on the
carabiner (1) and pull the perforated
rail (2) out of the carabiner.
The unit is balanced differently
depending on the cutting attachment
used.
N With the unit suspended from the
harness, see how it is balanced and
change attachment point as
necessary:
Floating Positions
Brush knives should just touch the
ground.
Circular saw blades should "hover"
about 20 cm above the ground.
Fitting the Full Harness
3
002BA411 KN
1
2
2
1
002BA631 KN
1
2
2
1
002BA632 KN
1
2
Balancing the Machine
6BA009 KN
6BA010 KN