Operation Manual

FS 410 C, FS 410 C L
English
32
Installing the Spark Plug
N Screw the spark plug into the
cylinder.
N Press the spark plug boot firmly
onto the spark plug.
N Fit the cap (1) on the shroud from
the rear and push the lug (2) into the
opening (3) in the shroud at the
same time.
N Swing the cap forwards onto the
shroud, insert and tighten down the
screw (4) firmly.
If engine running behavior is still
unsatisfactory after the air filter has been
serviced and the carburetor and throttle
cable have been adjusted correctly, the
cause may also be in the muffler.
Have the muffler checked for
contamination (coking) by a servicing
dealer!
STIHL recommends that maintenance
and repair work be carried out only by
authorized STIHL dealers.
To help prolong the wear life of the
starter rope, observe the following
points:
N Pull the starter rope only in the
direction specified.
N Do not pull the rope over the edge of
the guide bushing.
N Do not pull out the rope more than
specified.
N Do not allow the starter grip to snap
back, guide it back into the housing
slowly – see chapter on "Starting /
Stopping the Engine."
Have a damaged starter rope replaced
by your dealer before it breaks
completely. STIHL recommends that
you have servicing and repair work
carried out exclusively by an authorized
STIHL servicing dealer.
4
3
2
9926BA022 KN
Engine Running Behavior Rewind Starter