Operation Manual

FS 410 C, FS 410 C L
English
24
Fuel Filler Cap
WARNING
When fueling on a slope, always position
the machine with the filler cap facing
uphill.
N Place the machine on level ground
so that the filler cap is facing up.
N Before fueling, clean the filler cap
and the area around it to ensure that
no dirt falls into the tank.
Opening the filler cap
N Turn the cap counterclockwise until
it can be removed from the tank
opening.
N Remove the cap.
Filling Up with Fuel
Take care not to spill fuel while fueling
and do not overfill the tank.
STIHL recommends you use the STIHL
filler nozzle for fuel (special accessory).
N Fill up with fuel.
Closing the filler cap
N Place the cap in the opening.
N Turn the cap clockwise as far as
stop and tighten it down as firmly as
possible by hand.
Fitting the full harness is described in
detail in the instruction sheet supplied.
N Put on the full harness (1).
N Adjust the length of the strap so that
the carabiner (2) is about a hand’s
width below your right hip.
N Attach the spring hook to the
machine's perforated strip (3).
Find the right attachment point for the
cutting attachment you are using – see
"Balancing the Brushcutter".
Fueling
2709BA025 KN
2709BA003 KN
2709BA004 KN
Fitting the Full Harness
3
002BA411 KN
1
2