Instruction Manual

FS 240, FS 240 R
English
31
Controls
Version with bike handle
1 Throttle trigger lockout
2 Throttle trigger
3 Stop switch with Run and Stop
positions. Press the stop switch
(…) to switch off the ignition – see
"Function of stop switch and ignition
system".
Version with loop handle
1 Throttle trigger lockout
2 Throttle trigger
3 Stop switch with Run and STOP-
0 = stop positions. The stop switch
must be moved from F to STOP-0
(h) to switch off the ignition.
Function of stop switch and ignition
system
The ignition is switched off and the
engine stopped when the stop switch is
operated. The stop switch returns
automatically to the Run position when it
is released: The ignition is switched on
again after the engine stops – the engine
is then ready to start.
Starting the Engine
N Press the manual fuel pump
bulb (4) at least five times – even if
the bulb is filled with fuel.
Cold engine (cold start)
N Press in the outer edge (arrows) of
the choke knob (5) and then turn it
to g .
Also use this setting if the engine has
been running but is still cold.
Hot engine (hot start)
The engine has reached normal
operating temperature, then shut down
and restarted after more than 5 minutes.
Starting / Stopping the
Engine
1
002BA483 KN
2
3
1
002BA393 KN
3
2
STOP-
4
9926BA006 KN
5
9926BA007 KN
5