Instruction Manual

FS 240, FS 240 R
English
50
Spacer, shim
check X
Replace
2)
XX
All accessible screws, nuts and bolts (not
adjusting screws)
Tighten
3)
X
Anti-vibration elements
Visual inspection
4)
XX
Replace
2)
X
Cutting attachment
Visual inspection XX
replace X
Check for secure fit XX
Metal cutting attachment sharpen XX
Gearbox lubrication (with screw plug)
check XXX
top up X
Safety information label replace X
1)
Only if there is a noticeable loss of engine power
2)
STIHL recommends that this work be done by a STIHL servicing dealer
3)
Tighten the screws for the muffler after a running time of 10 to 20 hours after commissioning
4)
see chapter "Inspection and Maintenance by Dealer", section "Antivibration Elements"
The following intervals apply for normal operating conditions. The specified intervals
must be shortened accordingly when working for longer than normal or under difficult
cutting conditions (extensive dust, etc.).
Before starting work At the end of work and/or daily Whenever tank is refilled Weekly Monthly Annually If faulty If damaged As required