Instruction Manual

FS 240, FS 240 R
English
22
Mounting the Control Handle
N Take out the screw (9) – remove the
nut (10) from the control
handle (11).
N Push the control handle onto the
end of the handlebar (7) until the
holes (13) line up – the throttle
trigger (12) must point towards the
gearhead.
N Fit the nut (10) in the control handle,
insert the screw (9) and tighten it
down firmly.
Fitting the throttle cable
NOTICE
Do not kink the throttle cable or lay it in
tight radii – make sure the throttle trigger
moves freely.
N Position the clamp (15) and handle
support (14) against the drive tube.
N Close the throttle cable
retainer (15). The retainer (15)
snaps into place.
Swiveling the Handlebar
Transport position
N Loosen the wing screw (3) and
unscrew it until the handlebar (7)
can be rotated.
N Rotate the handlebar 90°
counterclockwise and then swing
the handles down.
N Tighten down the wing screw (3)
firmly.
Working position
N Reverse the sequence described
above to swing the handles up and
turn the handlebar clockwise.
13
9
11
12
7
13
002BA438 BL
10
14
15
15
14
002BA378
7
3
002BA651