Operation Manual

FS 240, FS 240 R
English
20
N Hold the lower clamp (1) steady and
remove the upper clamp (2) –
separate the parts so that the
springs (4, 5) remain in position in
the lower clamp.
If the spring (5) has slipped out of the
lower clamp (1):
N Fit the spring in the clamp's annular
groove as shown.
Securing the handlebar
N Place the handlebar (7) in the lower
clamp (1) so that distance A is no
more than 15 cm (6 in).
N Place the upper clamp in position
and hold both clamp moldings
together.
N Push the wing screw (3) through the
two clamps as far as stop – hold all
parts together and secure them.
N Place the secured assembly on the
handle support (8) with the wing
screw at the side nearest the
engine.
N Push the wing screw (3) into the
handle support as far as stop and
then screw it down – but do not
finally tighten yet.
N Line up the handlebar at a right
angle to the drive tube – check
distance A again.
N Tighten down the wing screw firmly.
2
1
4
5
002BA415 KN
1
5
002BA416 KN
A
3
7
002BA381 KN
1
2
3
002BA351 KN
8