Instruction Manual

FS 131, FS 131 R
English
21
N Push the thrust washer (3) (convex
side up) over the shaft (1) until it is
seated on the base.
N Block the shaft.
N Use the combination wrench (5) to
screw the mounting nut (4) onto the
output shaft and it tighten down
firmly.
WARNING
If the mounting nut has become too
loose, fit a new one.
NOTICE
Remove the tool used to block the shaft.
Removing the Mowing Head
N Block the shaft.
N Use the combination wrench to
loosen and unscrew the mounting
nut counterclockwise from the
output shaft.
Mounting Metal Cutting Attachments
Keep the leaflet and packaging of the
metal cutting attachment in a safe place.
WARNING
Wear protective gloves to reduce the
risk of direct contact with the sharp
cutting edges.
Mount only one metal cutting
attachment.
Check direction of rotation of cutting
attachment
Cutting attachments 2, 4, 5 and 6 may
be mounted either way round – they
must be turned over regularly to help
avoid one-sided wear.
The cutting edges of cutting
attachments 1, 3, 7 and 8 must point
clockwise.
Direction of rotation is indicated by an
arrow on the inside of the deflector.
N Fit the thrust plate (9).
N Place the cutting attachment (8) on
the thrust plate (9).
Collar (see arrow) must engage the
cutting attachment's mounting hole.
Securing the cutting attachment
N Fit the rider plate (10).
N Block the shaft (11) with the stop pin
(12).
N Use the combination wrench (14) to
screw the mounting nut (13) on to
the output shaft counterclockwise
and tighten it down firmly.
WARNING
There is a risk of injury if the cutting
attachment works loose. If the mounting
nut has become too loose, fit a new one.
1
681BA303 KN
2
3
4
5
6
7
8
8
9
10
11
13
14
0000-GXX-0502-A0
12