Instruction Manual

FS 110, FS 110 R
English
33
Switching off the engine
N Push the slide control in the
direction of the arrow at the stop
sign h to STOP-0
At very low temperatures
As soon as engine is running:
N Blip the throttle trigger = disengage
starting throttle position – the slide
control jumps to run F – engine
begins to idle
N Press the throttle trigger slightly
N Let the engine warm up briefly
If the engine does not start
Choke knob
If the choke knob was not returned to e
in time after the engine turned over for
the first time, then the engine has
flooded.
N Turn the choke knob to e.
N Move the slide control, throttle
trigger interlock and throttle trigger
to the starting throttle position
N Start the engine – to do this, pull the
starter rope briskly – 10 or 20 pulls
may be needed
If the engine still does not start
N Set slide control to STOP-0
N Remove the spark plug - see "Spark
plug"
N Dry the spark plug
N Crank the engine several times with
the starter – to clear the combustion
chamber
N Replace the spark plug – see "Spark
plug"
N Set the slide control to START
N Turn the choke knob to e – even if
the engine is cold!
N Restart the engine
Adjusting the throttle cable
N Check throttle cable adjustment –
see "Adjusting the throttle cable"
If the tank has been drained completely
N After refueling, press the manual
fuel pump bulb at least five times –
even if it is full of fuel.
N Set choke lever depending on
engine temperature
N Restart the engine
Using a transport guard
The type of transport guard used
depends on the type of metal cutting
attachment supplied with the machine.
Transport guards are also available as
special accessories.
Fitting the transport guard for grass
cutting blades 230 and brush knives
The transport guard can be used for
grass cutting blades up to 230 mm
(9.1 in.) in diameter and for brush knife
250-3.
If a grass cutting blade 230 is fitted:
Transporting the Unit
681BA268 KN
681BA269 KN