Operation Manual
Adjusting nylon line
• Hold the rotating mowing head
horizontal above the ground -
tap
it
on the ground -
about
3cm/1 1/4" fresh line
is
advanced - blade on deflector trims
surplus line
to
the correct length -
avoid tapping head more than
once.
• Line feed operates only if both lines
still have a
minimum length
of
2.Scm/1".
• Fit new nylon line as described
in
instructions supplied with mowing
head.
c;-
2
1
3
4
"c
I~
STIHL Autocut 24-2
STIHL
Polymatic 30-2
• Lay your brushcutter on its back
with the gear head facing up.
• Slip the plain washer
(1) and
thrust washer
(2) over the
shaft
(3) and against the
thrust plate (4).
• Screw mowing head counterclock-
wise onto the output shaft -
as far as
it
will go.
• Block the output shaft.
• Tighten down the mowing head
securely.
Important!
Remove the stop pin.
Keep instruction sheet for mowing
head in a safe place.
Removing mowing head
• Block the output shaft.
•
Uns.f.rew mowing head clockwise.
Adjusting nylon line
• Refer to instruction sheet supplied
with mowing head.
27