Operation Manual

FG 3
English
19
N Measure tooth length (A)
If the tooth length varies from the length
of the master cutter:
N Move stop (3) forward or backward
and sharpen again
N Check tooth length (A)
N If necessary, repeat until there is no
longer any deviation
N Sharpen all cutters in the second
row of cutter using this setting
Depth gauge
N Select the appropriate file
gauge(special accessory) for the
chain pitch
N Place selected file gauge (1) on the
saw chain
N Check height of the depth gauge
If the depth gauge protrudes above the
file gauge, it must be reworked.
N Set sharpening angle on guide
piece to 0°
N Advance saw chain until a depth
gauge is under the file
N Replace round file with the
triangular file (2) (special
accessory)
N Set stop (3) so that the file does not
touch the cutting edge
N Set depth adjusting screw (4) so
that the depth gauge is filed down to
the necessary height (flush with the
gauge)
N Remove the file gauge and file all
depth gauges with this setting
566BA024 KN
A
566BA025 KN
3
Chain pitch File gauge
Inches mm Part number
1/4 6.35 1110 893 4000
3/8 P 9.32 1110 893 4000
0.325 8.25 1110 893 4000
3/8 9.32 1110 893 4000
0.404 10.26 1106 893 4000
564BA035 KN
1
564BA018 KN
30
35
564BA019 KN
33
2
566BA016 KN
4