Operation Manual

FG 3
English
17
N Turn the adjusting screw (7) (anti-
clockwise – file lower, clockwise –
file higher) until approx. 1/4 of the
diameter of the sharpening file
protrudes above the tooth head
N By turning theknurled nut (8), adjust
the stop (9) until it lies against the
back of the cutter that is to be
sharpened (master cutter)
N Then turn theknurled nut a little
further until the tooth face presses
against the file and the stop
tube (10) lifts up from the stop
roller (4) by approx. 0.1 to 0.2 mm
7
566BA009 KN
565BA030 KN
8
566BA020 KN
9
10
10
4
4
566BA021 KN