Operation Manual

19FG 3
english
: Remove round file and fit the
triangular file (2) 0811 421 8971 in
its place.
: Set filing angle to 0°.
: Pull chain along bar until the depth
gauge is under the file.
: Adjust stop (3) until it butts against
the back of the cutter.
: Rotate height adjusting screw (4) so
that the depth gauge is filed back to
the required height (flush with
gauge). Then remove the filing
gauge and file down all depth
gauges to the same setting.
: Finish off by filing the slope by hand,
parallel to the stamped marking,
until dimension “a” is approx.
0.5 mm.
3
2
566BA015 KN
566BA016 KN
4
566BA017 KN
a