Operation Manual

FG 2
English
21
N Adjust the stop (3) so that the file (2)
does not touch the cutting edge.
N Adjust the height adjusting
screw (4) so that the depth gauge is
filed back to the required height
(flush with the gauge).
N Remove the filing gauge and file
down all the depth gauges to the
same setting.
N File the top of the depth gauge
parallel to the stamped service
marking (see arrow) – but do not
lower the highest point of the depth
gauge in this process.
N Place the filing gauge on the chain –
the highest point of the depth gauge
must be level with the filing gauge.
WARNING
The kickback tendency of the saw is
increased if the depth gauges are too
low.
Chains with humped drive links
The upper part of the humped drive link
(with service marking) is lowered along
with the depth gauge.
WARNING
The other parts of the humped drive link
must not be filed since this may increase
the kickback tendency of the saw.
After sharpening
N Clean the chain thoroughly, remove
filings or grinding dust – lubricate
the chain thoroughly with oil.
N Lubricate the guide with oil at
regular intervals.
N Rotate the round file at regular
intervals while filing to avoid one-
sided wear.
564BA019 KN
33
2
564BA020 KN
4
564BA026 KN
564BA025 KN
Maintenance and Care
564BA024 KN
Oil