Operation Manual

18
English
FG 2
Turn the chain rest to suit the position of
the master cutter:
: Set the chain rest as shown in
illustration A if the master cutter is in
the left-hand row.
: Set the chain rest as shown in
illustration B if the master cutter is in
the right-hand row.
The sharpening procedure described
below assumes the master cutter is in
the left-hand row.
The procedure is the same if the master
cutter is in the right-hand row. Move the
chain rest to the position shown in
illustration B, reset the file, adjust angle.
Adjusting Filing Angle
: Check filing angle in the following
table.
: Swing the filing frame upwards.
: Loosen the nut (1).
: To rotate guide, lift it clear of the
teeth.
564BA005 KN
A
B
Chain Type Filing Angle
Rapid Standard (RC) 30 °
Rapid Micro (RM) 30 °
Rapid Super (RS) 30 °
Picco Micro (PM/PMN) 30 °
RCX, RMX, PMX
(ripping chain)
10 °
Adjustments
1
564BA006 KN
564BA007 KN