Operation Manual

21FG 2
English
Sharpening the Next Cutter
Use the setting for the master cutter to
sharpen all the other cutters in the row.
: Open the clamping lever.
: Pull the chain along to the next
cutter in the row – push cutter
against the stop.
Make sure the stop (3) always
locates properly against the back of
the cutter to be sharpened.
: Close the clamping lever.
: Sharpen the cutter.
: Repeat the procedure until all
cutters in one row have been
sharpened.
Sharpening the Second Row of
Cutters
: Swing the filing frame upwards and
loosen the nut (1).
: Lift the guide clear of the teeth and
turn it to the same filing angle on the
opposite side.
: Tighten down the nut.
: Turn the chain rest 180°, as
described under "Setting Up".
: Reset the file.
: Swing the filing frame down.
: Position the round file between the
side plate and depth gauge of the
first cutter in the second row.
564BA014 KN
3
1
564BA006 KN
564BA007 KN
564BA015 KN