Owner's Manual

17FCS
English / USA
Aligning the Loop Handle
: Adjust the loop handle (1) to the
most comfortable position for the
user and application.
Distance A must not be more than
55 cm (22“).
About 35 cm (14“) is recommended.
: Tighten down screws on loop
handle firmly.
Starting the engine
Always follow the starting procedure
described in the owner’s manual of the
basic power tool you are using.
: Make sure you have a firm footing.
Check that the edger blade is not
touching the ground or any other
obstacles!
: Hold the unit securely and press it
firmly against the ground with your
left hand.
If you start the engine in the START
positon, the edger blade may begin
to rotate as soon as the engine runs.
Do not run the engine for any longer
than necessary in the starting
throttle position.
To shut down the engine:
: Move the slide control in direction of
arrow ( h ) to STOP-O or move the
stop switch to O.
002BA183 KN
1
A
Starting / Stopping
the Engine
406BA007 KN
406BA008 KN