Owner's Manual

15FCB-KM
English / USA
: Place the power edger on a
suitable support so that the blade
mounting (1) faces upwards.
: Insert stop pin or offset screwdriver
– see "Special Accessories" – (2) as
far as possible in the bore (3) – push
lightly and rotate it back and forth
together with the thrust washer (4)
until the drive shaft is blocked.
: Fit combination wrench (5) on the
nut (6).
: Loosen and remove the nut
clockwise (left-hand thread).
: Remove the thrust washer.
: Position blade (7) on the thrust
plate (8).
Collar (see arrow) must engage
hole in blade.
: Fit thrust washer (4) on the shaft (9).
: Block the shaft.
: Screw the nut (6) on to the shaft
counterclockwise and tighten down
firmly.
If the cup spring (10) on the nut (6)
becomes fatigued, install a new nut.
Fitting the Edger Blade
241BA006 KN
1
6
3
2
4
5
241BA011 KN
6
10
8
9
241BA012 KN
7
4
7