Owner's Manual

14
English / USA
FCB-KM
Connecting drive tube to gearbox
: Loosen the clamp screw (1).
: Insert curved end of drive tube (3) in
the gearbox (2) – turn the gearbox
back and forth as necessary.
: Push the drive tube home as far as
stop.
: Screw in the clamp screw as far as
stop but do not tighten down yet.
: Align the gearbox (2) on the drive
tube so that the rib (4) is in line with
the drive tube.
Tighten down the clamp screw firmly.
Mounting
: Engage lug (1) on drive tube in
slot (2) in the coupling sleeve and
push home the drive tube as far as
stop.
: When correctly installed, the red
line (3) (arrow point) must be flush
with the end of the coupling sleeve.
: Tighten the wing screw (4) firmly.
Removing
: Reverse the above sequence to
remove the drive tube.
400BA001 KN
1
3
2
4
400BA002 KN
2
Mounting the KombiTool
002BA132 KN
1
2
4
3
002BA133 KN