Owner's Manual

11FCB-KM
English / USA
Your power edger is designed to
produce sharp contoured borders
around lawns and flower-beds. It will cut
almost all types of grass, weeds and soft
green plants.
Preparations
If the soil is very dry, spray it with water
before you start work: this softens the
soil a little and also reduces the amount
of dust created. Slightly damp green
plants are easier to cut.
: Inspect and clear the work area to
reduce the risk of injury from thrown
objects.
: Plan the best route for edging.
Always hold and operate your edger
on the right-hand side of your body.
Adjusting Depth of Cut
: Shut off the engine and wait for the
blade to come to a complete
standstill.
: Loosen the wingnut (1)
counterclockwise.
: Adjust the wheel (2):
Upwards to increase
depth of cut (A).
Downwards to reduce
depth of cut (A).
Adjust correctly
The depth of cut varies, depending
on uneveness of the ground, your
height and the way you hold the
edger.
Use the following procedure:
: Adjust the depth wheel (2) so that
the blade (3) just touches the
ground or breaks the surface of the
soil by no more than 1/4“ (5 mm) (B)
in the working position.
Using the Edger
241BA000 KN
2
1
241BA001 KN
A
B
241BA002 KN
2
3