Owner's Manual

30
English / USA
FC 75
Have worn depth wheel replaced by
your STIHL dealer.
: The end of the thread on screw (1)
is caulked to ensure that the
wingnut (2) does not work loose
and be lost.
A very high torque has to be applied to
remove the wingnut from the screw. If
the parts are then reassembled, the
captive function is no longer
guaranteed. In such a case the screw
and wingnut should be replaced by your
dealer*.
* STIHL recommends that this work
be done by a STIHL servicing dealer
Removing the skirt
: Release and remove screw (1)
along with washer (2).
: Pull the skirt (3) off the lug (4) and
out of the deflector
Position of skirt
: Position the skirt (3) correctly in
relation to depth wheel (5):
If wheel is on left, the skirt must
project to the right.
Fitting the skirt
: Push the skirt (3) into the slot in the
deflector until it can be engaged on
the lug (4).
: Fit the washer on the screw.
: Insert screw and tighten it down
firmly.
Replacing the Depth Wheel
1
241BA024 KN
2
Replacing the Skirt
3
4
241BA009 KN
1
2
5
241BA015 KN
3
241BA017 KN
3
4