Owner's Manual

FC 70 C
English
13
Adjusting Depth of Cut
N To reduce the risk of injury, shut off
the engine.
N Loosen the wingnut (1)
counterclockwise.
N Adjust the wheel (2): Upwards to
increase the depth of cut (A) or
downwards to reduce the depth of
cut (A).
Adjust correctly
The depth of cut depends on the
uneveness of the ground, your height
and the way you hold the edger. Use the
following procedure:
N Adjust the depth wheel (2) so that
the blade (3) just touches the
ground or breaks the surface of the
soil by no more than 0.2 in
(5 mm) (B) in the normal working
position.
N Tighten down the wingnut
clockwise.
N Standing in the normal working
position, check the depth of cut
again and correct it if necessary,
WARNING
Do not adjust the deflector.
The deflector has been set at the factory
so that the arrow on the deflector and
the open side point away from the
operator. This ensures that cuttings and
other debris are directed away from the
machine and operator.
2
1
241BA001 KN
A
B
241BA002 KN
2
3
241BA003 KN
0815BA004 KN