Instruction Manual

FC 56 C
English
15
Your new power tool comes with the
loop handle mounted on the drive tube,
but it must be turned and lined up to suit
your requirements.
Adjusting the Loop Handle
N Loosen the star knob (1).
N Turn the handle to the vertical
position.
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommended distance (A): about 6 in
(15 cm)
N Slide the handle to the required
position.
N Tighten down the star knob so that
the handle cannot be rotated on the
drive tube.
N Place the edger so that the blade
mounting (1) faces upwards
N Insert the locking pin (2) as far as
possible into the bore (3), push
lightly and rotate back and forth a
little together with the thrust washer
(4) until the shaft is blocked.
N Fit Allen wrench (5) onto nut (6).
Mounting the Loop Handle
1
546BA010 KN
545BA004 KN
546BA011 KN
A
Mounting the Cutting Blade
239BA020 KN
6
239BA021 KN
3
2
4
5