Instruction Manual

FC 56 C
English
16
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommendation: distance (A):
about 6 in (15 cm)
N Slide the handle to the required
position.
N Tighten down the star knob so that
the handle cannot be rotated on the
shaft.
Adjusting loop handle without star knob
screw
N Use the combination wrench to
loosen the screw (1).
N Turn the handle to the vertical
position.
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommendation: distance (A):
about 6 in (15 cm)
N Slide the handle to the required
position.
N Tighten down the screw with the
combination wrench so that the
handle cannot be rotated on the
drive tube.
N Place the edger so that the blade
mounting (1) faces upwards
N Insert the locking pin (2) as far as
possible into the bore (3), push
lightly and rotate back and forth a
little together with the thrust washer
(4) until the shaft is blocked.
N Fit Allen wrench (5) onto nut (6).
546BA011 KN
A
1
239BA008 KN
545BA004 KN
A
0000-GXX-1562-A0
Mounting the Cutting Blade
239BA020 KN
6
239BA021 KN
3
2
4
5