Instruction Manual

FC 56 C
English
15
operator. This ensures that cuttings and
other debris are directed away from the
power tool and operator.
Edging
N Start the engine
N Start the cut at no less than half
throttle and continue cutting at full
throttle.
N Hold and guide your power tool so
that the blade is vertical.
N Cut steadily so that the engine is not
lugged down – do not apply force.
N Operate at no more than a normal
walking pace.
N Do not push the blade into the
ground.
N Always walk forwards when cutting,
do not pull the unit towards you.
N Cut at a steady pace to avoid having
to make several passes.
N Use the gunning sight (1) to line the
blade up with the edge of the bed.
Your new power tool comes with the
loop handle mounted on the drive tube,
but it must be turned and lined up to suit
your requirements.
Adjusting loop handle with star knob
screw
N Loosen the star knob screw (1).
N Turn the handle to the vertical
position.
239BA016 KN
1
239BA017 KN
Mounting the Loop Handle
1
546BA010 KN
545BA004 KN