Owner's Manual

15FC 55
English / USA
: Tighten the wingnut clockwise.
: Standing in the normal working
position, check the depth of cut
again and correct it if necessary.
Edging
: Start the engine.
: Start the cut at no less than half
throttle and continue cutting at full
throttle.
: Hold and guide your edger so that
the blade is vertical.
: Cut steadily so that the engine is not
lugged down – do not apply force.
: Cut at a normal walking pace.
: Do not push the blade into the
ground.
: Always walk forwards when cutting,
do not pull the unit towards you.
: Edge at a steady pace to avoid
having to make several passes.
1 = Gunning sight for edger blade
241BA003 KN
241BA004 KN
90°
241BA005 KN
1