Owner's Manual

30
English / USA
FC 110
For periods of about 3 months or longer
: Drain and clean the fuel tank in a
well ventilated area.
: Dispose of remaining fuel and
cleaning solution properly in
accordance with local
environmental requirements.
: Run engine until carburetor is dry –
this helps prevent the carburetor
diaphragms sticking together.
: Remove, clean and inspect the
cutting blade.
: Thoroughly clean the machine – pay
special attention to the cylinder fins
and air filter.
: Store the machine in a dry, high or
locked location – out of the reach of
children and other unauthorized
persons.
Depth wheel
Have a worn wheel replaced by your
dealer*.
: The end of the thread on screw (1)
is caulked to ensure that the
wingnut (2) does not work loose and
be lost.
A very high torque has to be applied
to remove the wingnut from the screw.
If the parts are then reassembled, the
captive function is no longer
guaranteed. In such a case have the
screw and wingnut replaced by your
dealer
* STIHL recommends a STIHL
servicing dealer
Gearbox wheel
Have a worn wheel replaced by your
dealer*.
The wheel helps protect the
gearbox from wear. If the gearbox
wheel is worn, also check the wear
guard (arrow) and the gearbox for
signs of damage – see “Checking
and Replacing the Wear Guard”.
* STIHL recommends a STIHL
servicing dealer
Storing the Machine
Replacing Wheels
1
245BA017 KN
2
245BA018 KN