Owner's Manual

15FC 110
English / USA
: Fit the loop handle (1) on the drive
tube 8" / 20 cm (A) forward of the
control handle (2).
: Position the clamp (3) against the
drive tube and slide it into the loop
handle.
: Fit square nut (4) in the loop handle,
insert the clamp screw (5) from the
other side and tighten down
securely.
Adjusting loop handle to most
comfortable position:
: Release clamp screw (5).
: Move the loop handle along the
drive tube as required - retighten the
clamp screw.
A properly adjusted throttle cable is
the precondition for correct
operation in the full throttle, starting
throttle and idle positions.
Adjust the throttle cable only after
the unit is fully assembled.
: Use a suitable tool to push the slide
to the bottom of the slot (see
illustration).
* see "Guide to Using this Manual"
Mounting the Loop Handle
3
355BA030 KN
1
2
A
343BA023 KN
5
4
50 mm
( 2" )
Adjusting the Throttle
Cable*
002BA163 KN