Owner's Manual

14
English / USA
FC 110
: Retighten wing nut clockwise.
: Standing in the normal working
position, check the depth of cut
again and correct it if necessary.
Edging
: Start the engine.
: Start the cut at half throttle and
continue cutting at full throttle.
: Hold and guide the unit so that it is
vertical.
: Cut at a rate which suits the cutting
performance of the blade – do not
apply force!
: Set the cutting rate for a normal
walking pace.
: Do not push the blade into the
ground.
: Always push the edger forwards –
never pull it.
: Cut at a steady pace to avoid having
to make several passes.
: Gunning sight for cutting blade (1)
245BA007 KN
245BA008 KN
90°
245BA009 KN
1