Operation Manual

•
0HDVXUHJURRYHGHSWK
with scale on filing gauge* -
in area of nose on Duromatic bars -
or in area used most for cutting on
Rollomatic bars.
Chain Chain Minimum
type pitch groove depth
Rapid 3/8" 6.0 mm (0.24")
If groove depth is less than specified:
•
Replace the guide bar.
The drive link tangs will otherwise
scrape along the bottom of the
groove - the cutters and tie straps will
not ride on the rails.
* Special accessory
Replace the chain sprocket
- after using two Oilomatic chains.
- or even sooner if the wear marks D
on the sprocket are deeper than
approx. 0.5 mm (
1
/
64
") since this
would reduce the life of the chain.
You can use gauge* 0000 893 4101
to check the depth of the wear marks
on the sprocket.
1RWH It is best to use two chains in
rotation with one sprocket.
* Special accessory
%HIRUHUHPRYLQJFKDLQVSURFNHW
•
Disconnect saw from power supply
•
Remove chain sprocket cover,
chain and guide bar.
•
Remove screw  from the shaft.
•
Remove the cup springs ,
washers  and sprocket .
•
Reverse the above sequence to
install the new sprocket.
,PSRUWDQW Always XVHDQHZVFUHZ

when installing the chain sprocket.
Install all parts as shown in the
illustration.
a
100BA025 KN
1
2
3
4
3
107BA012 KN
&KHFNLQJDQG5HSODFLQJWKH
&KDLQ6SURFNHW
29