MS 201 T Chainsaw Manual

MS 201 T
English
49
EPA / CEPA
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
CARB
The Emission Compliance Period used
on the CARB-Air Index Label indicates
the terms:
Engine
Single cylinder two-stroke engine
Ignition System
Electronic magneto ignition
Fuel System
All position diaphragm carburetor with
integral fuel pump
Chain Lubrication
Fully automatic, speed-controlled oil
pump. Additional manual oil flow control
Weight
Cutting Attachment
Recommended cutting attachments
complying with Section 5.11 of ANSI B
175.1-2000.
Observe notes on ANSI B 175.1-2000
and definition of "low kickback chain" in
chapter on "Safety Precautions and
Working Techniques".
Rollomatic E guide bars
3/8" P chain
Chain sprocket
To ensure compliance with the kickback
properties required in Section 5.11 of
ANSI B 175.1-2000, only use
Specifications
A = 300 hours
B = 125 hours
C = 50 hours
Extended = 300 hours
Intermediate = 125 hours
Moderate = 50 hours
Displacement: 2.15 cu.in (35.2
cm
3
)
Bore: 1.60 in (40 mm)
Stroke: 1.10 in (28 mm)
Engine power to
ISO 7293:
2.4 hp (1.8 kW)
at 9,500 rpm
Idle speed: 3,000 rpm
High speed setting
when performing
repairs (with bar and
chain): 14,000 rpm
Spark plug (resistor
type): NGK CMR 6 H
Electrode gap: 0,02 in (0.5 mm)
Fuel tank capacity: 10.5 fl.oz (0.31 L)
Oil tank capacity: 7.4 fl.oz (0.22 L)
dry, without bar and
chain: 8.2 lbs (3.7 kg)
Reduced kickback STIHL guide bar
(with green label)
Cutting lengths: 12, 14, 16 in (30,
35, 40 cm)
Pitch: 3/8" P (9.32 mm)
Groove width: 0.50in(1.3mm)
Nose sprocket: 9-tooth
Low kickback STIHL saw chain (with
green label)
Picco Micro 3 (63 PM3) Type 3636
Pitch: 3/8" P (9.32 mm)
Drive link gauge: 0.050 in (1.3 mm)
Picco Super 3 (63 PS3) Type 3616
Pitch: 3/8" P (9.32 mm)
Drive link gauge: 0.050 in (1.3 mm)
Picco Duro 3 (63 PD3) Type 3612
Pitch: 3/8" P (9.32 mm)
Drive link gauge: 0.050 in (1.3 mm)
6-tooth for 3/8" P (spur sprocket)