MS 201 T Chainsaw Manual

MS 201 T
English
35
If there is a noticeable loss of engine
power:
N Turn cap 90° to the left
N Lift off the shroud
N Lift off the air filter
N Wash the filter with STIHL special-
purpose cleaner (special
accessories) or a clean, non-
flammable cleaning liquid (e.g.,
warm soapy water) and dry it
NOTICE
Do not clean fleece filters (depending on
version) with a brush.
Always replace a damaged filter.
Exhaust emissions are controlled by the
design of the fundamental engine
parameters and components (e.g.
carburation, ignition, timing and valve or
port timing) without the addition of any
major hardware.
General Information
The carburetor comes from the factory
with a standard setting.
This setting provides an optimum fuel-air
mixture under most operating
conditions.
Preparations
N Shut off the engine.
N Check the air filter and clean or
replace if necessary.
N Check the spark arresting screen
(not in all models, country-specific)
in the muffler and clean or replace if
necessary.
Different Standard Settings
Different carburetors are installed at the
factory. A different standard setting is
necessary for each of these carburetors.
Standard setting A
– High speed screw (H) = 3/4
– Low speed screw (L) = 1 1/4
Standard setting B
– High speed screw (H) = 3/4
– Low speed screw (L) = 1/4
Cleaning the Air Filter
0012BA012 KN
0012BA013 KN
Engine Management Adjusting the Carburetor