MS 201 T Chainsaw Manual

MS 201 T
English
31
Cranking
N Pull the starter grip slowly with your
right hand until you feel it engage –
and then give it a brisk strong pull
and push down the front handle at
the same time. Do not pull out the
starter rope to full length – it might
otherwise break. Do not let the
starter grip snap back. Guide it
slowly back into the housing so that
the starter rope can rewind properly.
Machines without additional manual fuel
pump: If the engine is new or after a long
out-of-service period, it may be
necessary to pull the starter rope several
times to prime the fuel system.
Starting the Saw
WARNING
Bystanders must be well clear of the
general work area of the saw.
N Push the hand guard (1) forward –
the chain is locked.
N Press down the trigger lockout (2)
and pull the throttle trigger (3) at the
same time. Set Master Control
lever (4) to:
Choke shutter closed (l)
– If the engine is cold (also use this
position if the engine stopped when
you opened the throttle after
starting)
Starting throttle position (n)
– If the engine is warm, i.e. if it has
been running for about one minute.
N Hold and start your saw as
described.
When engine begins to fire
N Move the Master Control lever (1) to
the starting throttle position (n).
N Hold and start your saw as
described.
0012BA008 KN
0012BA009 KN
2
3
4
H
L
1
STOP
0012BA010 KN
1
H
L
STOP