MS 201 T Chainsaw Manual

MS 201 T
English
22
A cutting attachment consists of the saw
chain, guide bar and chain sprocket.
The cutting attachment that comes
standard is designed to exactly match
the chain saw.
– The pitch (t) of the saw chain (1),
chain sprocket and the nose
sprocket of the Rollomatic guide bar
must match.
– The drive link gauge (2) of the saw
chain (1) must match the groove
width of the guide bar (3).
If non-matching components are used,
the cutting attachment may be damaged
beyond repair after a short period of
operation.
Releasing the chain brake
N Pull hand guard towards the front
handle until it engages audibly –
chain brake is released
Removing the chain sprocket cover
N Turn the captive nut (1) to the left
until it hangs loosely in the chain
sprocket cover
N Remove the chain sprocket
cover (2) with captive nut
Fitting the guide bar
N Turn screw (1) to the left until the
tensioner slide (2) butts against the
left end of the housing slot
N Fit the guide bar over the screw (3)
and engage the peg of the tensioner
slide in the locating hole (4)
Fitting the saw chain
WARNING
Put on protective gloves – risk of injury
by the sharp cutters!
Cutting Attachment
001BA248 KN
1
2
3
a
Mounting the Bar and Chain
0012BA002 KN
H
L
1
0011BA002 KN
2
161BA027 KN
1
2
3
4
161BA028 KN