Owner's Manual

BF-MM, BK-MM
English
12
Mounting the MultiTool
N Arrange the blades in the order they
will be fitted on the shaft, noting the
following points:
Left-hand and right-hand blades are
different. The direction of rotation is
marked with arrows on the gearbox and
blades.
N Rotate the inner right-hand
blade (4) on the shaft until it can be
pushed into position – check the
direction of rotation again (arrows).
The hub of the inner blade is larger than
that of the outer blade.
N Rotate the outer right-hand
blade (5) on the shaft until it can be
pushed into position – check the
direction of rotation again (arrows).
N Insert and engage the hitch pin (6)
in the hole in the shaft – fold the
hitch pin flat against the blade.
N Use the same procedure to mount
the rotor blades on the left-hand
side.
Starting the Engine
Always follow the starting procedure
described in the MultiEngine instruction
manual.
N Secure the handlebar in the normal
operating position.
N Retract the wheels, if fitted – see
chapter on "Wheels" in MultiEngine
instruction manual.
N Retract the spur, if fitted.
N Place the unit on the ground: Check
that the blades are not touching the
ground or any other obstacles. The
unit must rest on the engine flange
and the support on the frame.
N Make sure you have good balance
and secure footing – as shown in
the illustration.
N With your left hand on the loop
handle, press the unit firmly against
the ground – do not touch the
throttle trigger or lockout lever.
Now follow the starting procedure
described in the MultiEngine instruction
manual.
To shut down the engine
N See MultiEngine instruction manual.
469BA029 KN
4
5
6
Starting / Stopping the
Engine
To reduce the risk of injury from
contact with the rotating
blades, always stand to the side
of the power tool, never in front of
or near the blades
469BA023 KN
Do not stand or kneel on the
handlebar or frame.
The blades may begin to rotate as
soon as the engine starts. For this
reason, blip the throttle after
starting – the engine returns to
idling speed.