Owner's Manual

BF-MM, BK-MM
English
11
Only use MultiEngines supplied by
STIHL or expressly approved by STIHL
for use with the MultiTool.
This MultiTool may only be used in
combination with the STIHL MM 55
MultiEngine.
Removing Existing MultiTools
N Remove the hitch pin and pull the
MultiTools (if fitted) off the shaft –
see also "Mounting the MultiTool" in
the instruction manual of the other
MultiTool.
N Clean the gearbox if necessary.
Checking Position of Gearbox
Gearbox output shaft (1) below the drive
tube (2).
Direction of rotation (3) of MultiTool.
Adjusting Position of Gearbox
N Loosen clamp screws on gearbox.
N Turn the gearbox through 180°.
N Line up the gearbox in the correct
position.
N Tighten down the two clamp screws
on the gearbox in the following
sequence:
– Tighten the first screw moderately.
– Tighten the second screw
moderately.
– Tighten down first screw firmly.
– Tighten down second screw firmly.
Approved MultiEngines Mounting the MultiTool
Wear gloves to reduce the risk
of injury from contact with sharp
MultiTools and/or hot surface of
gearbox.
To reduce risk of injury from the
MultiTool rotating in the wrong
direction, check that position of
gearbox is correct and adjust if
necessary.
481BA008 KN
It must not be possible to rotate
the gearbox on the drive tube.
2
469BA043 KN
1
3