Owner's Manual

BGA 85
English
22
Troubleshooting
Always remove the battery before carrying out any work on the power tool.
Condition Cause Remedy
Machine does not run when switched on
No electrical contact between power tool
and battery
Remove battery, check contacts and refit
battery
Battery discharged
(1 light emitting diode on battery flashes
green)
Charge the battery
Battery too hot / too cold
(1 light emitting diode on battery glows red)
Allow battery to cool down / Warm up bat-
tery slowly at a temperature of 60°F to
70°F (15°C–20°C).
Fault in battery
(4 light emitting diodes on battery flash red)
Take the battery out of the power tool and
refit it. Switch on the power tool – if the
light emitting diodes still flash, the battery
is faulty and must be replaced.
Power tool too hot
(3 light emitting diodes on battery glow red)
Allow power tool to cool down
Fault in power tool
(3 light emitting diodes on battery flash red)
Take the battery out of the power tool and
refit it. Switch on the power tool – if the
light emitting diodes still flash, the power
tool is faulty and must be checked by a
servicing dealer
1)
.
Moisture in power tool and/or battery Allow power tool/battery to dry