Operation Manual

BGA 85
English
45
Machine cuts out during operation
Battery or machine's electronics too warm Take battery out of machine, allow bat
-
tery and machine to cool down
Electrical or electromagnetic fault Remove the battery and refit it
Running time is too short
Battery not fully charged Charge the battery
Useful life of battery has been reached or
exceeded
Check battery
1)
and replace
Battery jams when being inserted in power
tool / charger
Guides / contacts dirty Carefully clean the guides / contacts
Battery is not being charged even though
LED on charger glows green
Battery too hot / too cold
(1 light emitting diode on battery glows red)
Allow battery to cool down / allow battery
to warm up slowly at temperature of
about 15°C - 20°C
Operate charger only in closed, dry
rooms at ambient temperatures between
+5°C and +40°C
Light emitting diode on charger flashes red
No electrical contact between charger and
battery
Remove the battery and refit it
Fault in battery
(4 light emitting diodes on battery flash red
for about 5 seconds)
Take the battery out of the power tool
and refit it. Switch on the machine – if the
LEDs continue to flash, the battery is
faulty and must be replaced.
Fault in charger Have charger checked by servicing
dealer
1)
1)
STIHL recommends a STIHL servicing dealer.
Always remove the battery before carrying out any work on the power tool.
Condition Cause Remedy