Operation Manual

BGA 85
English
35
The light emitting diode (1) on charger
glows continuously green or flashes red.
Green continuous light ...
... indicates the following:
The battery
– is being charged
– is too hot and must cool down
before charging
See also "Light Emitting Diodes (LEDs)
on Battery".
The green light emitting diode on the
charger goes off as soon as the battery
is fully charged.
Red flashing light ...
... indicates the following:
– No electrical contact between
battery and charger – remove and
refit the battery
– Malfunction in battery – see also
"Light Emitting Diodes (LEDs) on
Battery".
– Malfunction in charger – have
checked by a servicing dealer.
STIHL recommends a STIHL
servicing dealer.
The starter battery of a factory-new
machine is not fully charged.
Recommendation: Fully charge the
battery before using it for the first time.
N If necessary, remove the cover from
the battery compartment before
fitting the battery, i.e. depress both
locking tabs to unlock and remove
the cover.
Fitting the Battery
N Insert the battery (1) in the power
tool – the battery slides into the
compartment – press it down
carefully until it snaps into position –
the battery must be flush with the
top of the housing.
Switching on the Machine
N Make sure you have a secure and
firm footing.
N Stand upright – hold the power tool
in a relaxed position.
Light Emitting Diodes (LED)
on Charger
1
3901BA019 KN
Switching On
1
3905BA011 KN