Owner's Manual

•
Put the unit on the ground.
•
Make sure you have a firm footing:
Hold the unit with your left hand and
press it firmly against the ground.
•
Pull the starter grip slowly with your
right hand until you feel it engage -
and then give it a brisk strong pull.
Do not pull out starter rope more
than 30" (75 cm) - it might break.
Do not let the starter grip snap back.
•
Guide it back slowly so that starter
rope can rewind properly.
When engine begins to fire:
•
Move choke lever to H
and continue cranking.
$VVRRQDVHQJLQHUXQVblip the
throttle trigger, the slide
control then moves to the
"Run" position 
and the returns to idling speed.
•
To shut down the engine:
Move the slide control to .
$WYHU\ORZRXWVLGHWHPSHUDWXUHV
$OORZHQJLQHWRZDUPXS.
•
As soon as engine runs:
•
Blip the throttle trigger =
slide control moves to the
"Run" position 
engine returns to idling speed.
•
Open throttle slightly - warm up
engine for short period.
,IWKHHQJLQHGRHVQ¶WVWDUW
If you did not move the choke
lever to H
quickly enough after the engine
began to fire, the combustion
chamber hasflooded.
Remove spark plug terminal .
•
Unscrew and dry off the
spark plug.
•
Set slide control to "0".
•
Engage the throttle fully.
•
Pull the starter rope several
times to clear the combustion
chamber.
•
Refit the spark plug and connect
the spark plug terminal.
•
Set slide control to 
•
Set choke lever to H
even if engine is cold.
•
Now start the engine.
326BA012 L
Ä
326BA013 L
Ä
%* 