Instruction Manual

0458-967-8621-A
11
English 13 SPECIFICATIONS
13.1 STIHL AL 1
– Mains voltage: See rating plate
– Rated current: See rating plate
– Frequency: See rating plate
– Charging current: See rating plate
– Rated power: See rating plate
– Insulation: See rating plate
– For optimum performance, STIHL recommends operating
the charger within an ambient temperature range of: 41 °F
to 86 °F (5 °C to 30 °C)
WARNING
￭ A typical household electrical circuit is between 15 and
20 amps. A single STIHL AL 1 charger draws
approximately 0.275 amps. To reduce the risk of fire from
overloading an electrical circuit:
– Ensure the electrical system is rated to withstand the
expected electrical draw before charging your
battery.
– Charge multiple batteries one at a time or on
separate circuits, unless you know your circuit can
handle the total expected draw from multiple
chargers.
13.2 Symbols on the Charger
13.3 Engineering Improvements
STIHL's philosophy is to continually improve all of its
products. As a result, engineering changes and
improvements are made from time to time. Therefore, some
changes, modifications and improvements may not be
covered in this manual. If the operating characteristics or the
appearance of your machine differs from those described in
this manual, please contact your STIHL dealer or the STIHL
distributor in your area for assistance.
13.4 FCC 15 Information to the User
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
– reorient or relocate the receiving antenna,
– increase the separation between the equipment and
receiver,
13SPECIFICATIONS
Symbol Explanation
VVolt
Hz Hertz
A Ampere
WWatt
Certification/listing mark of UL
Direct current
Read the manual
Use and store charger only indoors in dry rooms