Owner's Manual

ADG 1
English
4
Never store the battery in the analyzer.
Mains voltage and operating voltage
must be the same.
N Insert the mains plug (1) in the wall
outlet (2).
The following information is displayed
(shown with gray background):
A self test is performed after the unit is
connected to the power supply. During
this process the light emitting diode (3)
on the unit lights up green for about 1
second, then red and goes off again.
When self test is completed:
N Insert the battery in the unit – see
"Testing battery".
N Connect the unit to the power
supply – mains voltage and
operating voltage of the unit must be
the same – see "Connecting Unit to
Power Supply".
N Wait for unit to run self test – there is
no need to insert a battery in the unit
to select a language.
N Press the button on the unit – see
"Main Parts" – for about 3 seconds
to activate language selection.
N Press the button (about 1 second) to
select the required language.
N To confirm the language selected,
press the button on the unit again
for about 3 seconds.
The language can be changed at any
time.
Connecting Analyzer to
Power Supply
Battery analyzer
ADG 1
Self test
Insert the battery.
3
4901BA001 KN
2
1
Selecting Language