Operation Manual

7HQVLRQLQJUHZLQGVSULQJ
•
Make a loop in the unwound starter
rope and use it to turn the rope
rotor six full revolutions in the
direction of the arrow.
•
Hold the rotor steady -
straighten the twisted rope -
•
Release the rotor -
•
Let go of rope slowly so that it
winds onto the rotor.
•
The starter grip must sit firmly in the
rope guide bush. If the grip drops to
one side: Increase spring tension
by one additional turn.
•
When starter rope is fully extended
it must be possible to rotate the
rotor at least another half turn. If
this is not possible, the spring is
over-tensioned and could break.
Take off one turn of the rope.
•
Fit the fan housing on the crank-
case.
•
Set the Master Control lever to E
•
Push the remaining rope into the
starter grip so that the nipple 
is flush with the grip.
5HSODFLQJDEURNHQ
UHZLQGVSULQJ
•
Lubricate the new spring with a few
drops of non-resinous oil.
•
Remove the rope rotor-
see "Replacing Starter Rope".
•
Remove the spring housing and
parts of spring.
•
Fit the new spring housing -
bottom plate must face upward -
slip outer spring loop over lug -
•
Reinstall the rope rotor, tension the
rewind spring, fit the fan housing
and secure in position.
•
If the spring pops out of its housing
during installation: refit it in the
counterclockwise direction, starting
outside and working inward.
001BA006 K
001BA007 K
8
 