Operation Manual

•
Use a screwdriver to pry the rope
out of the starter grip.
•
Remove remaining rope from the
rotor and starter grip.
•
Thread the new rope -
Part No. 1122 190 2900 -
through the top of the starter grip
and then pull through the rope
guide bush .
Thread the rope through the rotor
and secure it with a simple overhand
knot.
•
Coat rope rotor bearing bore with
non-resinous oil.
•
Slide rotor onto starter post -
turn it back and forth so that anchor
loop of rewind spring engages -
•
Refit the pawls in the rotor -
•
Fit the washer  on the starter post
•
Use screwdriver or suitable pliers
to install spring clip on starter
post and over the pawl pegs -
the spring clip must point in
clockwise direction -
see illustration.
001BA004 K
5
6
5
7
001BA005 K
001BA003 K
4
 