Operation Manual
2QO\PDFKLQHVZLWK
GHFRPSUHVVLRQYDOYH
•
Press in the button.
Compression pressure is released
when the button is pressed in.
This helps reduce the effort requi-
red to pull the starter rope.
•
For this reason the button should
be pressed in before each starting
attempt.
$OOYHUVLRQV
•
Observe safety precautions -
see section "Safety Precautions".
•
Press throttle trigger interlock
and set
•
Master Control lever to:
For cold start O
For warm startQ
(even if engine has
been running but is still cold)
•
Place your saw on the ground -
make sure you have a firm footing -
check that chain is not touching any
object or the ground -
bystanders must be well clear of
general work area of the saw -
•
Hold the saw firmly on the ground
with your left hand on the
front handle -
your thumb should be under
the handle -
•
put your right foot into the rear
handle and press down.
6WDUWLQJWKH6DZ
133BA001 K
2
1
0
STOP
143BA017 KN
143BA018 KN