Operation Manual

You can run chains of different pitches
on this chainsaw - depending on the
chain sprocket (see "Specifications")
The chain pitch must match the guide
bar. The drive link gauge must match
the guide bar groove width.
•
Unscrew nuts and take off cover
•
Turn tensioning screw 
counterclockwise until the peg of
the tensioner slide butts against
left end of housing slot.
•
Wear work gloves to protect hands
•
Fit the chain - start at the bar nose.
Disengage the chaine brake:
Pull hand guard  toward the front
handle.
Fit the guide bar over the
studs  -
cutting edges on top of bar
must point to right -
and engage the peg
of the tensioner slide in
locating hole -
place the chain over
sprocket at the same time -
0RXQWLQJ
WKH%DUDQG&KDLQ
143BA003 KN
143BA004
3
1
2
6
4
4
5
 