Operation Manual

Locating the guide bar
Top: Fitting the chain
Center: Peg in fixing hole -
cutting edges point toward bar nose
Bottom: Drive link tang
125BA006 LA
4
79
8
125BA005 LA
7
6
125BA004 LA
10
125BA007 LA
Starting at the chain sprocket , place the Oilomatic chain
on the guide bar so that the cutting edges on the top of the
bar point toward the bar nose . Now pull the guide bar
forwards until the peg of the tensioning nut  engages the
lower fixing hole . The bar should now fit against the
housing.
Now tension the chain by turning the tensioning screw 
clockwise until the chain sags only slightly at the bottom of
the bar. Make sure that the drive link tangs  are located
in the bar groove.
Refit the sprocket cover , making sure that the rear of the
sprocket cover locates in the housing seat below the rear
handle as you push it over the stud bolt . On Quickstop
models the chain brake must be disengaged and the top
end of the lever (11) must be located in the slot in the hand
guard .
