Owners manual

33
3
2
Figure 7
5
7
23
7
4
23
33
Detail E
11. Lay out Rails (#2, #3, #23 & #33) around edges of
table top. See Figure 7.
13. Line up holes in rails with indentations in table top and
secure using Screws (#5). See Figure 7 & Detail F.
12. Place Ball Holder end Plugs (#7) in both ends of Ball
Holder end Rail (#4). See Figure 7 & Detail E.
14. Attach Net Plate as shown in Detail 1A & Detail 1B.
Make sure the Nut Plate is flush with the corner of the
table and make sure to use the top three holes in the
nut plates. Note: Nut Plates Mount to one Table
Top Only.
5
44
44
Detail 1A
Detail 1B
Flush
Flush
No screw in
this hole
No screw in
this hole
5
Detail F
Note: There are no Indentations guides for
the nut plates on the table top.